73
Diagnostics
In the Diagnostics mode you can access the following menus without interrupting
the measurement:
Viewing the calibration data
Viewing the sensor data
Starting a device self-test
Viewing the logbook entries
Displaying currently measured values
Displaying device type, software version, serial number
Access to diagnostics can be protected with a passcode (SERVICE menu).
Note:
HOLD is not active during Diagnostics mode!
Action Key Remark
Activate
diagnostics
Press menu key to call the selection menu.
Select DIAG using keys,
confirm by pressing enter
Select diagnos-
tics option
Use keys to select from:
See next pages for further proceeding.
Exit
meas Exit by pressing meas.
To Next Page
Loading...
