Knick Stratos MS A405 Series - Error Messages; Sensoface Messages

82
Error Messages
Error
Info text
(is displayed in case of fault when
the Info key is pressed)
Problem
Possible causes
ERR 60 OUTPUT LOAD
Load error
ERR 61 OUTPUT 1 TOO LOW
Output current 1
< 0 (3.8) mA
ERR 62 OUTPUT 1 TOO HIGH
Output current 1
> 20.5 mA
ERR 63 OUTPUT 2 TOO LOW
Output current 2
< 0 (3.8) mA
ERR 64 OUTPUT 2 TOO HIGH
Output current 2
> 20.5 mA
Sensoface messages:
Cell factor monitoring SENSOR CELL FACTOR
CALIBRATE OR CHANGE SENSOR
Table monitoring
(TC/Conc/Sal/USP)
OUT OF INTERNAL TABLE
Zero point monitoring SENSOR ZERO CALIBRATE OR CHANGE SENSOR
Cell factor / zero point
monitoring
SENSOR ZERO/CELL FACTOR
CALIBRATE OR CHANGE SENSOR
Sensor TAG does not corre-
spond to device entry.
WRONG SENSOR TAG
Sensor GROUP does not
correspond to device entry.
WRONG SENSOR GROUP xxxx