28
Protos 3400(X)
SW 3400-012:
ISFET for PH 3400(X)-035 ISM Module
Connection for ISM sensor (e.g. Mettler-Toledo InPro 3300)
Note:
Each time a new sensor is connected, you must perform an ISFET zero
adjustment to adjust the operating point.
After that, you should perform one of the following calibration methods:
• Calimatic: automatic calibration
• Manual entry of buffer values
• Data entry: premeasured electrodes
Jumper
PH 3400(X)-035
To Next Page
Loading...
