43
SW 3400-106: Software Update
For a software update (additional function SW3400-106), the manufacturer
supplies a specially formatted SmartMedia card. The analyzer replaces its own
firmware (operating program) by the new version (“Update”).
Caution!
During a software update the analyzer is not operable!
After a software update you should check the configuration.
This icon indicates that a SmartMedia card is inserted in the slot.
The card allows storing of current device software on the card
as well as loading of new software into the analyzer.
1. Save the firmware currently installed in your analyzer (Pg. 44).
UP
2. Load the software update as described on Pg 45.
Note:
A memory card can be generated by formatting an update card (irreversible!).
See Page 33.
To Next Page
Loading...
