18
b. STABILIZATION PROCEDURE
The stabilization procedure is useful when evident pan drifts are noticed such as to compromise the quality
of the tracking and it takes only 20 seconds. To stabilize KOALA, simply keep it still and start the procedure
under SETUP MENU > STABILIZATION > RUN PROCEDURE or from the SETUP WEB PAGE.
Please remember that after this procedure it is preferable to keep KOALA still for at least 5 minutes to
correctly complete the stabilization procedure.
If, even after completing the STABILIZATION procedure, no improvement is evident, it is advisable to
power OFF KOALA, wait for a few seconds, and then restart the device.
c. AUTOMATIC STABILIZATION
Automatic mode (in SETUP MENU > STABILIZATION > AUTO ON/OFF) will stabilize KOALA during inactive
periods and after warm-up phase.
It is recommended to avoid environments that negatively interfere with KOALA (see section 18.d)
16. OTHER FUNCTIONS
KOALA provides additional functions:
a. SMOOTH FILTER
This function applies a data interpolation filter to make the motion smoother.
It is recommended to keep the filter turned OFF to minimize data transmission delay if necessary.
You can adjust the intensity from the SETUP WB PAGE.
b. SCREEN SAVER
This function proves useful for two reasons: firstly, like all OLED displays, reducing usage when not
necessary is advisable to prolong its lifespan. Secondly, in situations where minimizing light emissions from
devices is essential, such as when using KOALA in a theater audience.
The screen saver is enabled from SETUP MENU > SETUP > SC. SAVER ON/OFF, and after about 15 seconds
of inactivity, the display turns OFF. To turn the display back on, simply touch the button.
c. CUSTOM MESSAGE
It is possible to customize a message to be displayed on the home page of the display.
This can be useful for visually identifying multiple KOALAs in the same setup, such as specifying the name
or number of the camera. It also allows for branding or including reference contacts.
It can be done through the SERVICE WEB PAGE.
d. INTERFERENCE TEST
Through this function, you can verify in real-time if there is magnetic interference at the mounting point
of KOALA and the CRANE option (in CRANE mode). The indicator should remain in the GOOD zone and
never in the BAD or AWFUL zones; if it does, you must find a location free of interference.
e. RECALIBRATION
Recalibrating the sensors at the core of KOALA's operation is a critical process and should only be carried
out on the manufacturer's recommendation in case of sensor malfunctions that could compromise its
To Next Page
Loading...