6
4. OPERATING AREA
KOALA has two operating areas: Production and Service.
a. PRODUCTION
When KOALA is powered ON by default, it enters in Production.
In Production, KOALA generates tracking data.
Through the web interface you can set measurements, offsets, ID, sync, etc and directly from the display,
you can check tracking data, network parameters, and various convenient functions such as Pan and Lens
resets or autolevel.
b. SERVICE
In Service, you can find all the settings related to basic configurations, such as licenses, Wi-Fi parameters,
mounting type, mode selection, as well as factory data reset and software OTA update.
To enter in Service, you need to press and hold the touch button (on the right side of the display) for 5
seconds during startup or after a reboot. You will notice a small white pixel in the top left corner of the
display while holding down the button. Continue holding the button until the service mode is initiated.
Below are listed the functions
To Next Page
Loading...