A-61075 March 1997
OM-7
Error Code Number and Message Required Action(s)
Operator Action
If necessary, note the document that was skewed
greater than the defined maximum angle and press
the C (clear/cancel) key to clear the error message
(optional). This error message is just a warning to the
operator; if the displayed error message is ignored the
present scanning can be continued and the error
message will be cleared at the completion of scanning
when the Stop or End key is pressed. If the error
message persists, contact the system administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
Operator Action
Press the C (clear/cancel) key to clear the error
message, then verify the current Image Level and
Image Address. This error message is just a warning
to the operator; if the C (clear/cancel) key is pressed
the error message will be cleared and the present
scanning can be continued. If the error message
persists, contact the system administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
Operator Action
Press the C (clear/cancel) key to clear the error
message (optional), then press the Next key to input a
correct Image Address. This error message is just a
warning to the operator. If the error message is
displayed when the transport system is not running
and if the error message is cleared by pressing the
C (clear/ cancel) key, normal scanning can be
performed. If the error message is displayed while
scanning, the displayed error message can be
ignored and the present scanning can be continued
and the error message will be cleared at the
completion of scanning when the Stop or End key is
pressed. If the error message persists, contact the
system administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
E113_Incorrect
Image_Address
E107_Doc_Skew
Monitor_Warning
E112_Invalid
Patch_Level
To Next Page
Loading...
