A-61075 March 1997
OM-8
Error Code Number and Message Required Action(s)
Operator Action
Press the C (clear/cancel) key to clear the error
message, verify the current Image Level and Image
Address. This error message is just a warning to the
operator; if the C (clear/cancel) key is pressed the
error message will be cleared and the present
scanning can be continued. If the error message
persists, contact the system administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
Operator Action
Press the C (clear/cancel) key to clear the error
message (optional), then press the F key to input a
different function code or to select an Application
Mode that has been enabled for the desired
accessory during mode configuration. If the selected
accessory is desired in the current Application Mode,
service must be called to change the mode
configuration. This error message is just a warning to
the operator; if the error message is cleared by
pressing the C (clear/cancel) key, normal scanning
can be performed. If the error message persists,
contact the system administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
Operator Action
Press the C (clear/cancel) key to clear the error
message, verify the current Image Level and Image
Address. This error message is just a warning to the
operator; if the C (clear/cancel) key is pressed the
error message will be cleared and the present
scanning can be continued. If the error message
persists, contact the system administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
E114_Check
Current_IA/Level
E116_Accessory
Not_Mode_Enabled
E118_Check
Current_IA/Level
To Next Page
Loading...
