A-61075 March 1997
OM-14
Error Code Number And Message Required Action(s)
Operator Action
Note the document that was skewed greater than the
defined maximum angle and press the C (clear/
cancel) key (optional) to clear the error message and
then press the Run key to restart the transport
system. The Image Address is automatically set to the
correct address, but verify the Image Address and
Image Level, and then rescan the 0 Level documents
(usually only the skewed document). If the operator
does not have access to the Image Header to
determine which documents were assigned an Image
Level of 0, then contact the system administrator to
determine the last image that was transferred to the
host. If the error message persists, contact the
system administrator.
System Administrator Action
If required, view the Image Header and determine
which documents were assigned an Image Level of 0
and must be rescanned. Verify correct operation. If
the error message persists, call service.
Operator Action
Press the C (clear/cancel) key to clear the message
(optional), and press the Next key or one of the three
Level keys (if the current Application Mode is a multi-
level mode) to change the Image Address or Image
Level so that the corresponding field does not
overflow. Note the documents that have been
assigned an Image Level of 0. The Image Address is
automatically set to the correct address, but verify the
Image Address and Image Level, and then rescan the
0 Level documents. If the operator does not have
access to the Image Header to determine which
documents were assigned an Image Level of 0, then
contact the system administrator to determine the last
image that was transferred to the host. If the error
message persists, contact the system administrator.
System Administrator Action
If required, view the Image Header and determine
which documents were assigned an Image Level of 0
and must be rescanned. Verify correct operation. If
the error message persists, call service.
E205_IA_Overflow
Press_Next_Key
E204_Re-Scan_-
Skew_Monitor_Err
To Next Page
Loading...
