Setting Up the Printer
1-7
2. Insert your fingers into the holes in the plastic wrapper on the end of the
ribbon. Remove the plastic wrapper from the ribbon.
IMPORTANT: Do not remove the label from the ribbon at this time.
3. Push the bar code end of the supply spool onto the front spool holder on
the right.
4. Insert the left side of the supply spool onto the front spool holder on the
left. Align the notches on the supply spool with the lugs on the spool
holder.
5. Adjust the supply spool until the spool locks into the spool holder.
6. Remove the label.
To Next Page
Loading...
