1-8
Setting Up the Printer
7. Push the right side of the take-up spool onto the rear spool holder on the
right.
8. Insert the left side of the take-up spool onto the spool holder on the left.
9. Rotate the take-up spool until it locks into place.
10. If there is any slack in the ribbon, remove it by turning the supply spool.
IMPORTANT: Slack in the ribbon can cause a paper jam.
11. Close the top cover.
Loading the Paper
Make sure you have a KODAK Print Kit 6R (sold separately) available. This kit
contains the correct paper for your printer (see “Printer Supplies” on
page A-2).
1. Make sure the printer power is on ( | ).
2. Open the paper door. If you are replacing the paper, remove the used
paper roll.
3. Remove the plastic from the new paper roll.
IMPORTANT: Do not remove the label from the paper roll until you have
successfully loaded the paper in the printer.
To Next Page
Loading...
