Operating the Printer
2-3
Printer Settings
Use the operator panel buttons to review and change printer settings.
1. Press Menu to enter Setup Mode.
2. Press Menu repeatedly to scroll through the printer settings.
3. Press +/- to scroll through selections.
4. Press Enter to initiate an action or accept a change.
5. Press Clear to exit Setup Mode.
Printer settings
are displayed here
3
1,2
4 5
Display Description
Ready The printer is on and ready to make prints.
Energysave Mode
When selected, press Enter, then + or - to enable or disable Energy
Save mode (the default is off). When enabled, to conserve power, the
printer does not maintain printing temperature when idle. The printer
takes additional time to warm-up before initiating printing.
Test Print Mode When selected, press Enter to make a test print. See “Making a Test
Print” on page 1-11.
Remain = XXX/YYY XXX represents how many remaining prints you can make with the
current paper roll. YYY represents the total number of prints on a
paper roll. The counter is reset each time you press Paper Rewind.
Printed = XXXXXX XXXXXX represents the total number of prints made since the printer
was manufactured. This counter cannot be reset.
Donor = XXX[%] XXX[%] represents the percentage of the installed ribbon that is
available for making prints.
Main Firm = XX . YY XX . YY represents the printer control firmware version number.
DSP Firm = XX . YY XX . YY represents the image processing firmware version number.
USB Firm = XX . YY XX . YY represents the USB firmware version number.
TABLE Firm = XX . YY XX . YY represents the print parameter table version number.
To Next Page
Loading...
