Setting Up the Printer
1-9
4. Attach the paper flanges to each end of the paper roll:
a. Align the lugs on the green flange with the notches on the paper roll.
b. Insert the green flange into the notched end of the paper roll.
c. Insert the gray flange into the other end of the paper roll.
NOTE: If the paper flanges are not attached properly, the paper roll will not
fit into the printer.
5. Carefully lower the paper roll into the slots. Match the geared flange
(green) with the geared slot (green) on the printer.
6. Remove the label from the paper roll.
NOTE: Verify that the paper unrolls from the top of the roll.
Notches
Lugs
(green flange)
To Next Page
Loading...
