1-10
Setting Up the Printer
7. Feed the paper into the rear printer slot until the red LED light turns off
and the green LED light turns on.
8. Close the paper door.
NOTE: The ribbon must be loaded in the printer before the paper
automatically advances.
The printer advances the paper, then cuts and discharges 6 blank test
prints—about 24 in. (61 cm). This reduces the possibility of
fingerprints or other damage to the prints. It does not decrease the
1000 4 x 6 in. (10 x 15 cm) print capacity of the paper roll.
The operator panel displays the Ready message.
9. Empty and replace the trim tray.
NOTE: Empty the trim tray each time you change the paper to keep your
prints dust-free and to prevent paper jams.
To Next Page
Loading...
