Kodak 9810 - Accessing the Printer Settings

4-2
Operating the Printer
Accessing the Printer
Settings
Press Menu Scroll repeatedly to scroll through the printer settings in the
following order.
Printer Setting Operator Panel Display Action Required
Printer ready Ready None. The printer is on and ready to make prints.
Making a test print Test Print Mode Press Enter to enter test print mode. See “Making a test
print”.
Check remaining
media
Remain = XXX/YYY None. XXX represents the number of prints remaining out
of the total possible (YYY) for the media currently
installed.
Checking the printer
total print count
Printed = XXXXX None. XXXXX represents the total number of prints made
since the printer was manufactured. This counter cannot
be reset.
Checking the FEE
firmware version
FEE Firm X.XX None. The printer FEE firmware version is displayed.
Checking the DSP
firmware version
DSP Firm X.XX None. The printer DSP firmware version is displayed.
Checking the engine
firmware version
ENG Firm X.XX None. The engine firmware version is displayed.
Setting the operator
control panel (OCP)
language
Language
1. Press Enter.
2. Select the language.
Setting the standby
timeout
Standby Timeout
1. Press Enter.
2. Select the standby timeout (Never, 30 minutes, 60
minutes, 120 minutes, 480 minutes).
Setting the level of
matte lamination
Matte Level
1. Press Enter.
2. Select the level of matte lamination
(-4, -3, -2, -1, 0, 1, 2, 3, 4)