Kodak 9810 - Page 51

I-1
Index
A
air flow clearances, 1-1
C
cables, connecting, 1-8
calibrating the printer, 3-1
calibration errors, 3-9
calibration software
installing, 3-1
uninstalling, 3-8
calibration utility, using, 3-2
connecting cables, 1-8
customizing printer properties, 2-3
D
diagnostic tool, 5-1
disposal, B-3
E
error messages, calibration, 3-9
F
firmware, updating, 5-4
H
humidity, printer specifications, A-1
I
installing
calibration software, 3-1
paper, 1-2
printer driver, 2-2
ribbon, 1-6
L
labels, safety, B-2
loading
paper, 1-2
ribbon, 1-6
N
noise emission spec, B-3
O
operator panel
error/red light, 4-1
language, 4-2
making a test print, 4-2
power/orange light, 4-1
printer settings, 4-2
Ready message, 4-2
ready/green light, 4-1
setup mode, 4-2
standby timeout, 4-2
P
paper cutter and print head registration, adjusting, 5-1
paper, loading, 1-2
power
cable, 1-8
requirements, A-1
turning on, 1-9
preferences, 2-3
print head and paper cutter registration, adjusting, 5-1
printer
disposal, B-3
operating, 2-1, 4-1
preferences, customizing, 2-3
properties, customizing, 2-3
setting up, 1-1
settings, 4-1
specifications, A-1
test print, 4-2
troubleshooting, 6-1
printer driver
installing, 2-2
uninstalling, 2-9
printing problems, resolving, 2-7
product disposal, B-3
properties, 2-3