2-4 2G0733 January 14, 2008
Using and Maintaining the Imager
Web Portal
The Web Portal is your interface to additional functions on the Imager. In
the Web Portal, you can view and manage the Imager's connections over the
network, configure features, view and correct error messages and general
status, etc.
After you have accessed the Web Portal, you can check the status of the
Imager and check the media and status of the film trays.
With a user account, you can log on to the Web Portal to perform more
advanced functions such as:
• Setting up and working with network configuration for the imager
and connected image sources.
• Retrieving logs, statistics, and system status.
• Performing diagnostic utilities, including backup and restore.
Levels of User
Access
IMPORTANT: For information about creating user accounts refer to the
Web Portal Help system.
There are four levels of user access to the Imager.
Level 1: Operator - Activities include printing, clearing of some errors, and
removing film jams and deleting jobs. A password is not required
for this level of access.
Level 2: Key Operator - Activities include printing, clearing of some
errors, removing film jams, performing minor setup, and deleting
jobs. Access to Level 2 requires a Level 2 ID and password.
This icon indicates there are prints in the queue that are waiting to
be deleted.
This icon indicates that a user-initiated system restart is in
process.
This icon indicates that the Imager has been placed in service
mode.
This icon indicates that the Imager is warming up. The amount of
time remaining until the Imager reaches operating temperature is
also shown on the display screen.
Icon Description
To Next Page
Loading...
