2-12 2G0733 January 14, 2008
Using and Maintaining the Imager
5. Enter the desired density (0.1 to 3.2).
6. Use the drop-down menu to select the film tray.
7. Select the number of copies to be printed.
8. Click Run.
Removing Print Jobs
From the
Undeliverable Jobs
Queue
When there are jobs in the undeliverable jobs queue that can not be printed,
condition code 20703 and an icon show on the display screen. To remove
these jobs from the print queue, do the following.
1. Press and hold the Maintenance Reset LED/Button for 5 seconds.
Release the button and a menu selection is displayed.
2. Press and hold the Maintenance Reset LED/Button again for 5
seconds.
The icon and condition code are cleared, and the display screen
returns to normal operation.
Operator Maintenance
Changing the
Charcoal Filter
In the U.S., exhausted charcoal filters are considered to be
non-hazardous waste according to the US Environmental
Protection Agency Resource Conservation Recovery Act (RCRA).
Municipality owned and licensed solid waste management facilities
are an appropriate disposal option. Contact your local or state
solid waste authorities to determine if additional disposal
requirements apply. In other regions, contact local or regional
solid waste authorities for proper disposal guidance.
The preventive maintenance filter must be changed every 7,500 films.When
it is time to replace the filter, condition code 20449 and an icon show on the
display screen.
1. Remove the film trays see (“Inserting the Film Saver and Removing
the Film Tray”).
2. Turn the Imager OFF.
To Next Page
Loading...
