Kodak Dryview 5800 - Film Supply Status Messages

Troubleshooting
January 14, 2008 2G0733 3-3
Film Supply Status Messages
The following table describes how the local panel and Web Portal indicate
film supply status to the user.
Service
Mode
• Ready LED off
• Attention LED on
Status code: 20700
Service Mode WARNING /
PRINTER
OFFLINE
The service switch is
enabled. The Imager is not
"Ready".
Warming • Ready LED off
• Warming LED on
• Number of minutes
until warm shown
Warming=xx WARNING /
PROC INIT
The Processor is warming
up and will not be ready to
print for xx minutes.
Table 3-2: Printer Status Messages (Cont’d)
Printer
Status
Local Panel
Web Portal
Display
DICOM Status Description
Table 3-3: Film Supply Status Messages
Film Supply
State
Local Panel
Web Portal
Display
Description
Failed • Attention LED on
• Status code: 21000 (upper),
23000 (lower)
• Unlock button LED on
• Cal button LED flashing
• Supply info area displays icon
for this state
Failed An error has occurred that
affects normal operation. This
film supply is currently not
useable and requires user
intervention.
Calibrating • Attention LED on
• Status code: 21001 (upper),
23001 (lower)
• Unlock button LED on
• Cal button LED off
• Supply info area displays film
type, size, and count
Calibrating A calibration is in progress for
this film tray.
Film Covered • Attention LED on
• Status code: 21003 (upper),
23003 (lower)
Film is Covered Either the film bag or film saver
is still on and must be removed
before the film tray can be used.
Film Tray
Empty
• Unlock button LED on
• Cal button LED off
• Supply info area displays film
type, size, and count
Empty and/or
sheet count of 0
There is a film tray in the film
supply, but the sheet count is 0.