Using and Maintaining the Imager
January 14, 2008 2G0733 2-13
3. Raise the hood.
4. Pull the front panel forward.
5. Remove the charcoal filter by lifting it up and pulling it forward.
6. Install a new charcoal filter.
7. Close the front panel.
8. Close the hood.
9. Install the film trays.
10. Remove the film savers.
11. Turn the Imager ON.
12. Wait for the Imager to complete it’s start-up routine.
13. Clear the preventive maintenance icon and condition code.
a. Press and hold the Maintenance Reset LED/Button for 5 seconds.
Release the button and a menu selection is displayed.
b. Press and hold the lower LED/Button adjacent to the codes
displayed for 5 seconds. The preventive maintenance icon and
condition code are cleared, and the display screen returns to
normal operation.
Hood
Front panel
Charcoal filter
To Next Page
Loading...
