Kodak Dryview 5850 - Inserting the Film Saver and Removing the Film Tray; Removing Print Jobs From the Unprintable Jobs Queue

2-10 2G0733 2011-09-09
Using and Maintaining the Imager
Inserting the Film
Saver and Removing
the Film Tray
A film saver must be inserted into a film tray before:
• The hood is opened.
• Any panel on the imager is removed.
• Film tray with film in it is removed.
1. Insert the film saver as shown below.
2. If the film tray has not been unlocked, press the unlock button on the
local panel.
NOTE: The film tray must be removed within 30 seconds after pressing
the unlock button. Otherwise, the film tray will re-lock
automatically.
3. Remove the film tray as shown below.
Inserting the Film Saver
NOTE: The film saver can be stored under the film tray until required.
Removing Print Jobs
From the Unprintable
Jobs Queue
When there are jobs in the unprintable jobs queue that can not be printed,
condition code 20703 and an icon show on the display screen. To remove
these jobs from the print queue, do the following.
1. Press and hold the Menu Selection button for 5 seconds. Release the
button and the Test Print Menu displays.
2. Press and release the Menu Selection button again to display the Error
Reset Menu.
3. Check that the 20703 error is highlighted on the display screen, then
press the Enter button.
The icon and condition code are cleared, and the display screen returns to
normal operation.
H221_0002BC