Kodak Dryview 5850 - Film Tray Status Messages

Troubleshooting
2011-09-09 2G0733 3-3
Film Tray Status Messages
The following table describes how the local panel and Web Portal indicate
film tray status to the user.
Warming • Ready LED off
• Warming LED on
• Number of minutes
until warm shown
Warming=xx WARNING /
PROC INIT
The Processor is warming
up and will not be ready to
print for xx minutes.
Table 3-2: Printer Status Messages (Continued)
Printer
Status
Local Panel
Web Portal
Display
DICOM Status Description
Table 3-3: Film Tray Status Messages
Film Tray
State
Local Panel
Web Portal
Display
Description
Failed • Attention LED on
• Status code: 21000 (upper),
23000 (lower)
• Unlock button LED on
• Cal button LED flashing
• Tray info area displays icon
for this state
Failed An error has occurred that
affects normal operation. This
film tray is currently not useable
and requires user intervention.
Calibrating • Attention LED on
• Status code: 21001 (upper),
23001 (lower)
• Unlock button LED on
• Cal button LED off
• Tray info area displays film
type, size, and count
Calibrating A calibration is in progress for
this film tray.
Film Covered • Attention LED on
• Status code: 21003 (upper),
23003 (lower)
Film is Covered Either the film bag or film saver
is still on and must be removed
before the film tray can be used.
Film Tray
Empty
• Unlock button LED on
• Cal button LED off
• Tray info area displays film
type, size, and count
Empty and/or
sheet count of 0
A film tray is inserted, but the
sheet count is 0.