2011-09-09 2G0733 3-1
3 Troubleshooting
Error and Alarm Indications
The imager can detect errors and other conditions that require operator
action. These errors or abnormal conditions are reported on the display
screen and on the Web Portal in the form of condition codes and
messages.
DICOM Printer Status Messages
In response to a DICOM printer N-GET status request from a modality,
a printer status message and a printer status message are returned to the
requesting SCU. Every error has an associated printer status info
message. If more than one error exists when a printer N-GET request is
received, a status message is sent in response according to an
established priority. The following table shows the DICOM printer
status and printer status.
Table 3-1: DICOM Printer Status Messages
Printer
Status
Printer Status Printer Status Printer Status
FAILURE ELEC DOWN
PRINTER DOWN
PROC DOWN
WARNING BAD SUPPLY MGZ
CALIBRATION ERR
CHECK PRINTER
COVER OPEN
EMPTY MEDIASZ
MEDIATP
FILM JAM
FILM TRANS ERR
PRINTER BUSY
PROC INIT
PRINTER INIT
PRINTER OFFLINE
To Next Page
Loading...
