5-4 2G0733 2011-09-09
Specifications
Power Requirements
The imager power supply has an auto-sensing and auto-switching feature for
both voltage and frequency. The current draw is 10 A at 120 V (AC), and
the power consumption is a maximum of 1275 W.
One of the following single-phase, 15 A power sources, with grounding,
must be provided within 2.5 m (8.2 ft) of the imager.
The wire must be insulation-rated for 600 V. A dedicated line is
recommended.
Network Requirements
The imager receives digital images from medical imaging devices
(modalities) over a 10Base-T or 100Base-T Ethernet Network. A single
CAT 5 UTP cable is provided in the accessories package for the imager:
2.0 m (6.6 ft).
Film
Prior to installation, you must order and have on hand the appropriate film.
See the publications cover page for more information on film types that can
be used in this laser imager. Contact your sales representative if you have
questions.
Film Types The imager accommodates the following film types:
• KODAK DRYVIEW DVB Laser Imaging Film
• KODAK DRYVIEW DVC Laser Imaging Film
• KODAK DRYVIEW DVB+ Laser Imaging Film
• KODAK DRYVIEW DVB+ Premium Laser Imaging Film
• 5850 Laser Imager only: KODAK DRYVIEW Mammography
Laser Imaging Film and KODAK DRYVIEW DVM+ Mammography
Laser Imaging Film
NOTE: Not all film types are available in every country.
Area Power
North America 120 V (AC) From +6 through -10%, 60 Hz ±3 Hz
Europe 240 V (AC) ±10 %, 50 Hz ±3 Hz
China 220 V (AC) ±10 %, 50 Hz ±3 Hz
To Next Page
Loading...
