Support
Probable Cause 2
Sending device requires a PIN.
Corrective Action
Enter a PIN of 1111 into the sending device.
Device not Recognized
Any of the following can cause the prevent your Kodak EasyShare AiO from reading a connected digital
camera or memory card.
The camera is turned OFF.
The USB connector from the camera is not fully inserted in the port.
The memory card is not completely inserted.
The memory card is in backwards.
The memory card file system is corrupt.
Correct any connection problems and try again.
If the memory card file system is corrupt, reformat it in your camera.
Ink Cartridge
Color/Black Cartridge Not Recognized
The ink cartridge installed was not recognized. Generic ink cartridges can potentially damage the
printhead if the actual ink level is lower than that indicated.
To correct the problem, install a genuine Kodak ink cartridge.
Ink Cartridge out of Ink
One of the ink cartridges has reached the end of its life and needs to be replaced.
To correct the problem, replace the expired ink cartridge.
Multiple Paper Feed
Multiple sheets of paper are pulled through printer.
1 Disengage the Photo tray.
2 Remove the paper from the paper tray(s). Carefully "fan" the paper to keep the sheets from sticking
together.
3 Reload the paper tray(s). Do not overfill.
4 Re-engaged the Photo tray, then press Start to resume printing.
User’s Guide 127
To Next Page