6 www.kodak.com/go/support
Getting started
Setting the date and time
Setting the date & time, first time
The message
Date and Time have been reset
appears the first time you turn on the
camera or if the battery is removed for an extended time.
1 SET DATE & TIME is highlighted. Press the OK button.
2 Go to step 4 in Setting the date & time, anytime.
Setting the date & time, anytime
1 Turn on the camera. Press the Menu button.
2 Move the Joystick to highlight Setup Menu , then press the
OK button.
3 Move the Joystick to highlight Date & Time , then press the
OK button.
4 Move the Joystick to adjust the date and time. Move the
Joystick to advance to the next setting.
5 When finished, press the OK button.
6 Press the Menu button to exit the menu.
NOTE: Depending on your computer operating system, Kodak EasyShare software may update the camera
clock when you connect the camera. See the EasyShare software Help for details.
To Next Page
Loading...
Need help?
General
