A-61626 January 2010 41
Device - General tab The General tab allows you to set scanner-specific options and
provides access to scanner diagnostics.
Paper Source
• Automatic: looks for paper in the document feeder first. If there are
no documents in the input tray, the scanner will scan from the flatbed.
• Document Feeder: the scanner will only scan documents from the
input tray.
• Flatbed: scanner will scan from the flatbed.
NOTE: Automatic and Flatbed options are only available if you had
the flatbed accessory attached when the scanning application
connected to the scanner.
Power Saver — allows you to set the amount of time, in minutes, the
scanner has to be inactive before going into power saver mode.
Document Feeder
• Timeout: allows you to select the amount of time, in seconds, the
scanner will wait once the last document enters the feeder before the
timeout occurs.
Action when timeout occurs: indicates the action that will be taken
when the document feeder timeout has been reached.
- Stop Scanning: scanning will stop and control will return to the
scanning application (i.e. ends the job).
Diagnostics — displays the Diagnostics tab.
To Next Page
Loading...
