Kodak i1220 Plus - The Diagnostics Window; Diagnostics - General Tab

A-61626 January 2010 45
The Diagnostics
window
From this window you can access the diagnostic functions of the
scanner. The Diagnostics window includes the following tabs: General,
Component, Debug and Logs. The Diagnostics window can be
accessed via the Diagnostics button which is located on the General
tab of the Device Settings window.
Device — allows you to select which device to perform diagnostics on.
The options are: Document Feeder or Flatbed.
NOTE: This option is only available if you have the flatbed accessory
attached when the scanning application connected to the
scanner.
Done — returns you to the Device Settings window.
Diagnostics - General tab The General tab allows you to perform a scanner test and displays the
scanner time.
Tests
• Scanner — similar to, but more extensive than, a power-on self test.
Clicking this button will put the device through a series of checks to
determine that all the scanner hardware is working.
• Count only — counts the number of documents entering the scanner
without sending the images to a scanning application. This test is
performed during any san session in which this option is turned on.
NOTE: This test is automatically turned off when the scanning
application disconnects from the scanner.
Scanner Time
• Actual (GMT): displays the Greenwich Mean Time.
• Corresponding local time: displays the scanner’s Greenwich Mean
Time in the PC’s local time zone.
• Refresh icon : redisplays the current scanner time.