To Next Page
S
Sandy BrownAug 18, 2025
Why does the Kodak i1405 LED stay red even when connected?
- TTonya SmithAug 18, 2025
The LED on your Kodak scanner will remain a steady red until your application connects to the scanner.
Why does the Kodak i1405 LED stay red even when connected?
The LED on your Kodak scanner will remain a steady red until your application connects to the scanner.
What to do if my Kodak i1405 Scanner documents are jamming?
If documents are jamming in your Kodak scanner, ensure that the output tray and guides are adjusted for the document size. Remove all jammed documents from the paper transport area. Verify documents meet the size, weight, and type specifications. Remove all staples and paper clips. Ensure the separator and feed modules are clean and properly installed, and that the drive rollers and imaging guides are also clean.
Why is my Kodak i1405 not scanning or feeding documents?
If your Kodak scanner isn't scanning or feeding documents, check that the power cord is plugged in and the power is on. Ensure the scanner cover is completely closed and that you followed the correct power-up sequence, verifying the green light is on and the software has enabled scanning. Make sure documents contact the feed module. Ensure the document stack height is less than 10.2 mm or about 150 sheets of 60 g paper, and that documents meet size, weight, and type specifications. For thicker documents, lift the gap release lever. Inspect the feed and separator modules for wear and replace if needed. You can also try powering the scanner off and on again.
How to fix skewed documents during Kodak scanning?
To correct skewed documents during scanning with your Kodak scanner, make sure the document side guides are adjusted to fit the documents. Ensure documents are fed perpendicular to the feed module and centered in the ADF. Remove all staples and paper clips. Clean the feed module, separator module, and drive rollers. Also, ensure the scanner cover is firmly closed and latched.
What to do if the Kodak i1405 pauses excessively during scanning?
If your Kodak scanner pauses excessively, ensure the host computer meets the minimum requirements. Check for sufficient free space on the hard disk drive and close other applications. Verify the USB connection is 2.0. You can also try changing the scanning options, such as compression, in your scanning application.
How to resolve Kodak i1405 Scanner communication errors on Linux Fedora 7?
To resolve a communications error after installing Linux drivers on Fedora 7 with your Kodak scanner, before checking cable connections and power cycling: Click OK on the message, then go to System>Administration>SELinux Management. Enter your root/superuser password. In the SELinux Administration screen, select Permissive from both the System Default Enforcing mode and Current Enforcing mode drop-down lists. Close the SELinux Administration screen and try again.
How to resolve issues with long documents jamming in my Kodak i1405?
If 35.6 cm (14 in.) or longer documents are not feeding or are jamming in your Kodak scanner, make sure that the input and output tray extenders are pulled out to provide support for long documents.
How to fix roller marks or streaks on Kodak scanned documents?
To fix roller marks or streaks appearing on documents after scanning with your Kodak scanner, clean the feed module, separator module, and drive rollers.
How to fix vertical lines appearing on images from Kodak i1405 Scanner?
To fix vertical lines appearing on images from your Kodak scanner, clean the imaging guides.
How to fix Kodak i1405 Scanner failing after Windows Vista Standby or Hibernate?
If you cannot scan after Standby or Hibernate with Microsoft Windows Vista using your Kodak scanner, upgrade to Service Pack 1 or higher.
General| Film scanning | No |
|---|---|
| Color scanning | Yes |
| Grayscale levels | 256 |
| Input color depth | 48 bit |
| Maximum scan size | 297 x 863 mm |
| Output color depth | 24 bit |
| Optical scanning resolution | 600 x 600 DPI |
| Scanner type | Sheet-fed scanner |
| Product color | Black, White |
| Sensor type | CCD |
| Scan drivers | ISIS, TWAIN |
| Scan file formats | JPG, PDF, RTF, TIFF |
| Scanning noise level | 57 dB |
| Daily duty cycle (max) | 9000 pages |
| ISO A-series sizes (A0...A9) | A4 |
| Input voltage | 100-240 V |
| Power supply type | AC |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 60 W |
| USB version | 2.0 |
| Standard interfaces | USB 2.0 |
| Linux operating systems supported | Fedora 9, SuSE Linux 11, Ubuntu 8.04 |
| Server operating systems supported | Windows Server 2003, Windows Server 2003 x64, Windows Server 2008, Windows Server 2008 R2, Windows Server 2008 x64 |
| Windows operating systems supported | Windows 7 Home Basic, Windows 7 Home Basic x64, Windows 7 Home Premium, Windows 7 Home Premium x64, Windows 7 Professional, Windows 7 Professional x64, Windows 7 Starter, Windows 7 Starter x64, Windows 7 Ultimate, Windows 7 Ultimate x64, Windows Vista Business, Windows Vista Business x64, Windows Vista Enterprise, Windows Vista Enterprise x64, Windows Vista Home Basic, Windows Vista Home Basic x64, Windows Vista Home Premium, Windows Vista Home Premium x64, Windows Vista Ultimate, Windows Vista Ultimate x64, Windows XP Home, Windows XP Home x64, Windows XP Professional, Windows XP Professional x64 |
| Operating temperature (T-T) | 15 - 35 °C |
| Operating relative humidity (H-H) | 15 - 76 % |
| Sustainability certificates | ENERGY STAR |
| Standard input capacity | 150 sheets |
Weight and Dimensions| Depth | 300 mm |
|---|---|
| Width | 547 mm |
| Height | 365 mm |
| Weight | 10400 g |
