2-4 A-61651 December 2009
6. Secure the power cord and USB cable into the cable routing channel on
the back of the scanner.
Turning on the
scanner
• Press the Power button.
When you turn on the scanner, the input elevator will open if it is not already
opened and the green indicator on the Start/Resume button will flash as the
scanner goes through a series of self tests.
The scanner takes less than 15 seconds to complete the power-up sequence
and be ready to scan.
When the installation process is complete and ready to scan, the green LED
on the Start/Resume button will stop flashing and remain constant and the
number 1 will be displayed in the function window. If any other number is
displayed, see the section entitled, “LED error codes” in Chapter 6 for an
explanation of these codes.
Turning the scanner
off
• Press the Power button for one second.
To Next Page
Loading...
