A-61651 December 2009 4-5
6. Slide the printer carrier into the desired print position. See the section
entitled, “Changing print positions” later in this chapter for more
information.
7. Close the printer access cover and reinstall the output tray.
8. Run a print test (see the next section).
Running a print test You can only run a print test by using the Kodak Scan Validation Tool.
1. Place a blank sheet of paper in the input elevator.
2. Ensure that the ink cartridge is properly installed.
3. Select Start>Programs>Kodak>Document Imaging>Scan Validation
Tool.
4. Select TWAIN for the Driver Type and the KODAK Scanner: i4000. The
Scan Validation Tool dialog box will be displayed.
To Next Page
Loading...
