A-61651 December 2009 3-5
• Adjusting the side guides — open and adjust the side guides on the
output tray to match the position of the side guides on the input elevator.
The side guides can also be folded flat against the output tray.
• Adjusting the document stop — adjust the output tray document stop to
slightly longer than the longest document being fed. If you are scanning
documents longer than the output tray will accommodate, fold the document
stop flat on the output tray.
• Opening the rear document exit — documents that require special
handling (i.e., fragile documents, shipping envelopes, etc.) can be outputted
using the rear document exit. This exit provides the straight-through paper
path option that allows an exception document(s) to pass through the
transport, thus reducing the possibility of a document jam.
To Next Page
Loading...
