54 A-61671 / TWAIN February 2013
Sensors — five sensors cover the width of the paper path. In order for
multifed documents to be detected correctly, they must pass under one
of these sensors.
• Left through Right: these controls allow you to select which of the
five sensor(s) you want to have turned on. For example, if you know
that the left side of the document has a “sticky” note on it, you can
turn off the left sensor.
• Ignore up to: ignores a multifeed anywhere on the document that is
less than the value entered. This option is useful when you have a
known multifeed situation that you want to allow, but do not want to
have the sensor off for the entire document (e.g., 3-inch “sticky”
note).
NOTES:
- This option is available when at least one sensor is set to On -
Ignore.
- This length applies to all sensors set to On - Ignore.
Length Detection — allows you to select the maximum length of the
documents in your job set. If the scanner detects a document longer
than this value, it will determine that a multifeed has occurred. You can
turn this option off or set a length.
Action When Detected — select what action you want the scanner to
take when a multifeed is detected. With all options, the condition will be
logged in the scanner.
• Stop Scanning: scanning will stop and control will return to the
scanning application (i.e., ends the job). Verify that the paper path
has been cleared and restart the scan session from the scanning
application. The multifed page will be ejected. The multifed image will
not be sent to the host application.
• Stop Scanning - generate image(s): scanning will stop and control
will return to the scanning application (i.e., ends the job). Image(s) of
the multifed document will be generated. Verify that the paper path
has been cleared and restart the scan session from the scanning
application. The multifed page will be ejected.
• Stop Scanning - leave paper in path: scanning will stop
immediately (i.e., making no attempt to clear the paper path) and
control will return to the scanning application (i.e., ends the job).
Clear any documents from the paper path prior to restarting the scan
session from the scanning application. The multifed image will not be
sent to the host application.
• Continue Scanning: the scanner will continue to scan. The user-
configured multifeed sound will be made by the scanner.
• Pause Scanning: scanning will stop but the scanning application will
be waiting for additional images (i.e., stops the feeder). Scanning
may be resumed by pressing the Start/Resume button on the
scanner. Scanning may be stopped by pressing the Stop/Pause
button on the scanner or via the scanning application. The user-
configured multifeed sound will be made by the scanner.
To Next Page
Loading...
