Kodak i780 - Scanner Setup

2-2 A-61504 October 2007
Scanner setup To set up the scanner:
1. Set up your scanner operating conditions:
• simplex/duplex
• image order
• transport timeout
• transport timeout response
• length detection status and response
• multi-feed detection status and response
• starting document count
• Energy Star timeout
• printing parameters (printing status, print font, orientation and
strings)
• confirmation tone
For information on programming these conditions, see Chapters 3
or 4 (depending on your driver). For other vendor tool kits, refer to
their documentation.
2. Determine if any changes to the image processing parameters need
to be made for the current application.
NOTE: This check needs to occur for up to four separate images
from the six available options depending on your
application: Front Color, Front Black and white, Front
Grayscale, Rear Color, Rear Black and white, Rear
Grayscale.
Image Processing parameter changes remain in effect until one of
the following conditions occur:
• The scanner is powered down using the power switch.
• New imaging parameters are sent from the host.
3. Prepare documents according to the instructions found in the Kodak
i600/i700 Series Scanners User’s Guide.