3-42 A-61504 October 2007
Images
Received From Scanner: saves the images received at the PC from
the scanner.
• Held in memory: if scanning a large job and you only need to save
the last few images, then turn this on by selecting the number of
images you want to save.
NOTE: Turning this on will use more PC memory.
Sent to Application: saves the images received at the scanning
application from the scanner.
Simulation — allows you to use the TWAIN Datasource without using
the actual scanner.
• Model: allows you to select the specific scanner model to simulate.
• Flags: if supported by your TWAIN Datasource, this will contain a list
of accessories your simulated scanner has installed.
To Next Page
Loading...
