A-61504 October 2007 4-21
Area
• Snap causes the dimensions of the Area box to be controlled in
fixed 1/8-inch increments. This option is not available in Pixels mode.
• X: the distance from the left end of the scanner to the left-edge of the
scanning area.
• Y: the position from the top end of the document to the top end of the
scanning area.
• Width: the width of the scanning area.
• Height: the height of the scanning area.
Units — select whether you want the area to be defined in Pixels,
Inches or Centimeters.
To Next Page
Loading...
