28 Kodak Prosper S10 Printer
Chapter 3. Printer Maintenance
Cleaning
Cleaning
This section gives the areas that must be kept clean from dirt, paper dust,
and ink.
Clean the Print Station
Clean the print station weekly so it continues to operate correctly
(Figure 19).
1. Wipe off the cabinet exterior and connector panel with a clean, dry
spec wipe (PN 0204647) to remove dirt and paper dust.
2. If necessary, put on Kodak-approved gloves, wet a spec wipe
(PN 0204647) with storage fluid (PN 6080012-01) and wipe the
cabinet exterior to remove ink.
Figure 19 Print station
Clean the Print Station Cooling Fan Filters
On the print station, clean the cooling fan filters of dust as necessary, so
that the print station continues to operate correctly (Figure 20).
Turn off the print station before the cooling fan filters are cleaned.
Damage to the print station from dust can occur.
1. Do “Turn Off the Print Station” on page 16.
2. Open the print station front door.
3. Remove the dirty filter from the bracket.
a. Hold the filter by both sides and push up/down or left/right until
one edge clears a bracket.
b. Lift the filter out of the bracket.
External surfaces
Connector
panels