A-61601 February 2010 2-1
2 Installation
Contents Installing the scanner......................................................................2-1
Installation notes regarding Windows 7 and Windows XP..........2-2
Installing the Kodak Driver Software...........................................2-3
Attaching the standard output tray..............................................2-4
Attaching the optional output tray kit ..........................................2-5
Connecting the power cord and USB cable................................2-8
Turning on the scanner ...................................................................2-9
Starting the application software.....................................................2-9
Exiting the application software ......................................................2-9
Installing the scanner This section provides detailed information of the Installation Guide that
is provided with your scanner. Follow these steps in the order they are
provided to install your scanner.
NOTE: If you have already performed all of the steps in the Installation
Guide, skip this section.
• Power down any scanners attached to the PC before installing the
s1220 Photo Scanning Software application.
• Install the software before connecting the scanner to the PC.
• Be sure you have administrator rights. The s1220 Photo Scanning
System application must be installed under Administrator and run
under Administrator or Standard groups.
• Close any currently running applications.
• Close any currently running applications that use a USB software
dongle before starting the s1220 Photo Scanning System installation.
• Close any scanning applications including the Scan Validation Tool
and Smart Touch.
• Remove any USB software dongle connected to the PC.
To Next Page
Loading...
