5-6 A-61601 February 2010
6. Reinstall the feed module by aligning the pins and pushing it toward
the left to fit it into position. Be sure the gears are aligned and it
snaps into place. Roll the feed module back into place.
7. Reinstall the feed module cover by aligning the tabs with the slots
and pushing it back into position until it snaps into place.
Vacuuming the scanner Before cleaning the imaging area, it is suggested that you vacuum the
inside of the scanner to remove any dust and debris.
Cleaning the imaging area 1. Wipe the upper and lower imaging area using a “Step 1” Brillianize
Detailer wipe. Be careful not to scratch the imaging area when
cleaning.
2. Wipe the upper and lower imaging area again using the “Step 2”
Brillianize Detailer wipe to remove any debris and polish the
surface.
3. When finished, close the scanner cover with both hands.
To Next Page
Loading...
