A-61601 February 2010 5-1
5 Maintenance
Contents Opening the scanner cover.............................................................5-1
Cleaning procedures.......................................................................5-2
Cleaning the rollers ...................................................................5-2
Cleaning the separation module.................................................5-3
Cleaning the feed module ..........................................................5-4
Vacuuming the scanner..............................................................5-6
Cleaning the imaging area .........................................................5-6
Running a transport cleaning sheet............................................5-7
Replacement procedures ...............................................................5-8
Replacing the separation module and tires................................5-8
Replacing the pre-separation pad ............................................5-10
Replacing the feed module and tires ........................................ 5-11
Adjusting the pre-separation roller tension ...................................5-13
Supplies and consumables ..........................................................5-14
Opening the scanner
cover
1. Before opening the scanner cover, be sure the input tray is in the
open position and, if the optional output tray and/or dangler are
attached, remove them.
2. Press and hold the scanner cover release lever and pull the scanner
cover down.
3. When you finish cleaning the scanner or replacing a part, close the
scanner cover with both hands.
To Next Page
Loading...
