A-61601 February 2010 2-5
Attaching the optional
output tray kit
The Kodak s1220 Photo Scanner is shipped with an optional output tray
kit, which includes: an output tray extension and dangler. This output
tray is optional but is recommended when scanning large stacks of
photos or documents.
To install the output tray kit:
1. Remove the standard output tray from underneath the scanner by
pressing down on the two tabs and pulling the output tray out of
position.
2. Press and hold the tilt button and rotate the scanner body to the
downward position.
NOTE: The scanner must be in the downward position when using
this output tray.
dangler
output tray extension
To Next Page
Loading...
