A-61601 February 2010 7-7
Error Code Message Description
7000 Please check if WIBU runtime has been
installed. WIBU runtime (WkRuntime.exe)
can be found on the CD provided with the
Kodak scanner.
Contact Kodak Service.
7001 License .dat file not found. Please contact
support with error code 7001.
Contact Kodak Service.
8001 Profile error. Please verify that STW default
profile settings have not been altered. If this
error persists, please contact support with
error code 8001.
Reinstall the Kodak s1220 Photo Scanning System.
Refer to Chapter 2, Installation.
8002 Scanner name not found. Please verify that
STW default profile settings have not been
altered. If this error persists, please contact
support with error code 8002.
Reinstall the Kodak s1220 Photo Scanning System.
Refer to Chapter 2, Installation.
9001, 9002,
9003
TWAIN drivers could not be started. Please
retry. If this error persists, please contact
support with error code 900X.
Reinstall the Kodak s1220 Photo Scanning System.
Refer to the section entitled, “Installing the Kodak driver
software” in Chapter 2.
9004 Could not find a Kodak scanner. Be sure that the s1220 Scanner is attached, turned on
and the green LED is on and steady. If the error persists,
contact Kodak Service.
9005 Please check if scanner is available to STW. Verify that the s1220 Scanner is connected and
powered on. If the error persists, contact Kodak Service.
9006, 9007,
9008, 9010
Could not connect to the scanner. Please
retry. If this error persists, please contact
support with error code 900X.
Reinstall the Kodak s1220 Photo Scanning System.
Refer to Chapter 2, Installation.
9009 Could not get the image from the scanner.
Please retry. If this error persists, please
contact support with error code 9009.
Contact Kodak Service.
9011 Could not run the scanner. Please retry. If
this error persists, please contact support
with error code 9011.
Reinstall the Kodak s1220 Photo Scanning System.
Refer to Chapter 2, Installation.
XXXX Could not connect to scanner. Please retry. If
this error persists, please contact support
with error code XXXX.
Verify that the supplied s1220 USB software dongle is
plugged into a USB 2.0 port on the PC.
Error writing to file PrintScan.ini. Verify that a valid PrintScan.ini file exists. Reinstall the
Kodak s1220 Photo Scanning System. Refer to the
section entitled “Application configuration” in this
chapter.
To Next Page
Loading...
