Kodak Truper 3210 - Page 96

www.kodak.com/go/docimaging 96 of 144
Remove the retard roller from the metal brackets by holding the ends of the roller shaft and pulling
up the roller in the direction of the arrows, as shown in the following diagram.
Open the Roller Exchange Kit and take out the new retard roller.
Install the new retard roller as shown in the steps and diagram.
1. Hold the ends of the roller shaft and lower the roller into the metal brackets.
2. Match the groove on one side of the roller shaft with the metal bracket that fits the groove.
When the groove is matched with the bracket, the roller shaft slides into the bracket.
4
5
6
Groove