Koden CVS-126 - Page 9

CVS-126 Contents
0093132702-08 vii
Input / Output ............................. 3-1
Buzzer Setting ............................ 3-1
Temp Source .............................. 3-1
Speed Source ............................ 3-1
Baud Rate .................................. 3-1
NMEA Monitor ............................ 3-2
NMEA Output Data .................... 3-2
3.3 Setting of Correction Item .......... 3-2
Draft Set ..................................... 3-2
Sonic Speed ............................... 3-2
Water Temp ................................ 3-2
Boat Speed ................................ 3-2
Beam angle (Low/High) ............. 3-2
Bubble time set .......................... 3-3
3.4 Setting of Basic Set Item ........... 3-3
Language ................................... 3-3
Range & Speed Unit .................. 3-3
Depth Unit .................................. 3-3
Temperature Unit ....................... 3-3
Local time Offset ........................ 3-3
GPS select ................................. 3-3
GPS initialize .............................. 3-3
Sounding .................................... 3-3
3.5 Maintenance Menu .................... 3-4
Simulation .................................. 3-4
Slide show .................................. 3-4
Initialize ...................................... 3-4
System Check ............................ 3-4
All WPTs deletes ........................ 3-4
All stored image deletes ............ 3-4
Bottom start ................................ 3-4
Inner-hull .................................... 3-4
Universal display setting
( ) ............................. 3-4
Chapter 4 Maintenance and Inspection ... 4-1
4.1 Inspection ................................... 4-1
4.2 Cleaning ..................................... 4-1
CVS-126 Display unit ................. 4-1
Transducer ................................. 4-1
4.3 Fuse Replacement ..................... 4-2
4.4 If you suspect a trouble .............. 4-2
4.5 Diagnostic Test ........................... 4-3
Diagnose .................................... 4-3
Confirm the version .................... 4-3
Return to the menu .................... 4-3
Chapter 5 Installation .............................. 5-1
5.1 Items of Caution on Installation . 5-1
Unpacking the components ....... 5-1
Inspection of components and
accessories ................................ 5-1
Decision of Installing Location ... 5-1
Laying and Connection
of Cable ...................................... 5-2
Confirmation after Installation .... 5-2
5.2 Installation of CVS-126
Display unit ................................ 5-2
Desk-top Installation .................. 5-3
Flush-mount Installation ............. 5-3
5.3 Installation of Transducer ........... 5-5
In case of Inner-hull ................... 5-5
In case of Through-hull .............. 5-6
5.4 Wiring ......................................... 5-7
Connection of Cable to CVS-126
Display unit ................................ 5-7
Pin Assignment of Rear
Connector .................................. 5-7
Connection of Power Cable
and Transducer .......................... 5-8
Connection with external
equipment .................................. 5-9
Connection with GPS-20A ......... 5-9
Connection with Speed Sensor or
Water Temperature Sensor
(Option) .................................... 5-10
Connection of External Speaker
for Sona-Tone
TM