5. To set the tube
1. TURN OFF the power of machine.
2. For the tube w/o slit, set the tube nearby cutting blade.
3. For the tube w/slit, set the tube fixing slit part on “vertical guide”
and set it nearby cutting blade.
4. Turn ON the power when the tube is set.
Make sure the blade cover is not attached.
5. Set the switch on the operation panel to [DOWN].
The belt roller pinches the tube.
6. Hold down [F] on the control panel and press [+] to
feed the tube forward.
7. Stop feeding when the tube comes to 5mm left of
cutting blade.
To Next Page
Loading...