KODERA CASTING C372A - Daily Check-Up at Starting and Maintenance

20
14. Daily Check-up at Starting and Maintenance
Daily or regular checking and maintenance is essential to use machines for a long time in a
good condition without defects.
It may depend on the frequency in use. Please practice them referring to the chart below.
Daily Check-up & Maintenance
Item
Problems
1
Worn-out or chipping off of the blade
①Unable to cut.
②Cutting surface is not good.
③The speed of the cutting blade is slow.
How to check
Visually check keeping the blade as it stands.
To examine more, remove the blade and check it.
How to maintain
It is necessary to exchange the blade every 100 thousand
pieces of processing.
Exchange of the blade (See P. 15)
Item
Problems
2
Worn-out of the belt.
Length-measurement of the tube is not good.
How to check
Turn off the power. Visually check the belt, turning around
the belt with your hand.
How to maintain
Exchange of the belt. (See P. 14)
Item
Problems
3
Worn-out of the guide
The tube becomes bruised.
How to check
Visually check inside of the guide keeping the guide as it
stands.
To examine more, remove the guide and check.
How to maintain
Exchange of the guide. (See P. 8)