6.To start process
1. After replacing the guide and setting the tube, set the processing conditions.
2.Press ［LENGTH］,put the value and
[SET].
E.g.) : 1000mm →[1][0][0][0］[SET］
3.Press ［PIECES］, put the number and
[SET].
E.g.) : 50 pieces →[5][0][SET］
4.［STRAT］ and process starts.
5.After set pieces are done, machine stop running.
Change cutting blade speed
The speed of the cutting blade is adjusted by the speed controller.
1. Open the rear cover.
2. There are 2 controllers of Air.
Blue : For the move of blade goes down.
Red : For the move or blade goes up.
To Next Page
Loading...