Movie: *.avi files;•
TEXT: *.txt•
Note
Due to the particularity of file cording, some files ❏
may be unable to read.
Supported equipment:
B
Support the equipment that supports Mass Storage
Protocol and whose file system is FAT32, such
as some USB disks, mobile harddisks, and MP3
player. If USB equipment could not be identified
due to unsupported file system, please format the
equipment to the above-mentioned file system.
To achieve smooth playing, ensure the following:
C
The file code rate should be lower than 300KB/S;•
Due to the limitation of USB signal transmission •
distance, it is recommended not to use USB patch
cord, in case of using the cord, make sure that its
length is not over 1m;
Use high-speed USB equipment in conformity •
with USB2.0 full speed Interface Standard; If USB
equipment in conformity with USB1.1 full speed
Interface Standard is used, the playing may be
unsmooth.
When connecting/removing the USB
device
Press “A SOURCE” on the remote control unit to select
USB option.
Insert USB equipment into corresponding USB
B
interface 2s after starting the system.
After entering the system menu, press “
C 3/“ on the
remote control unit to select the require USB files,
press “OK” button to confirm the selection and enter
the file list relative to the selection.
Press D “5/“ on the remote control unit to select the
required file, press “OK” button to enter the selected file.
To exit the streaming media playing system and E
watch a TV program, you must press “BACK” button
to return to the streaming media main menu at first
(to protect equipment), and then press “SOURCE” to
select “TV” to return to the TV mode.
Note
Under source of USB, when ❑ press button MENU,
screen goes black, except when images or movies
are being played.
While playing the USB, press “ ❑ BACK” button
repeatly, the screen picture will return to USB
main interface, and only at this time you can
switch corresponding signal sources by pressing
“SOURCE” again.
Please do not unplug the USB device when the ❑
connected USB storage device is working. When such
device is suddenly separated or unplugged, the stored
files or the USB storage device may be damaged.
Operating the USB device
Press “A 5/“ to scroll through main menu or
submenu and select your desired option.
Press “
B OK” to confirm your selection.
Press “
C /“ to achieve the FWD (fast forward) and
REV (fast back) of the option being played.
Press “
D PLAY/PAUSE” to play, and press it again to
pause playing.
Press “E ZOOM” to magnify pictures; when the picture is
enlarged, press “3/“ and “5/“ to move the picture.
Press “F STOP“ to stop playing, or return to the
previous menu, and press “BACK” repeatedly to
return to the main menu.
Note
You can choose the photos or music in dierent ❏
files to play together.
Playing a Picture
After entering USB main interface, press A “3/“ to
select “PHOTO” item.
Press ”
B OK“ to confirm the selection and enter the
picture file list.
To Next Page
Loading...