Kohler Command CV17 User Manual

5B.31
Section 5B
EFI Fuel System
5B
Long Pause
Short Pause
Code 32
3
2
Code 61
1
6
Long Pause
Light remains on at end of transmission
1. Diagnostic display initiated through ignition key sequencing.
2.
Figure 5B-40.
After the problem has been corrected, the fault codes may be cleared as follows.
1. Disconnect the negative (-) battery cable or the main harness connector for one minute.
2. Reconnect the cable and tighten securely. Start the engine and allow it to run for several minutes. The MIL
should remain off if the problem was corrected, and the fault codes should not reappear (codes 31, 32, 33,
and 34 may require 10-15 minutes of running to reappear).
The following chart lists the fault codes, what they correspond to, and what the visual indications will be.
Following the chart is a list of the individual codes with an explanation of what triggers them, what symptoms
might be expected, and the probable causes.
Diagnostic Code Summary
Example of Diagnostic Display
Long Pause
3.
4.
5.
6.
7.
knilB
edoC
2DBO
edoC-P
elbacilppA
"niP23":ot
)1.1ESM(
-tsyS/UCE
ylnOme
noitpircseDeruliaFronoitcennoC
"niP42"
)0.1ESM(
desaC-citsalP
metsyS/UCE
"niP23"
)1.1ESM(
desaC-citsalP
metsyS/UCE
etoN
-- langiSMPRoNYY
125330PnoitazinorhcnySfossoLYY
220210PelbisualpmIlangiS-SPTNN2
222210PdnuorGottiucriCtrohSronepO-SPTYY
223210PyrettaBottiucriCtrohS-SPTYY
321060PUCEevitcefeDYY
42rosneSdeepSenignEYY9
134710PnaeLootmetsySYY6
Continue on next page.

Kohler Command CV17 Specifications

General

Brand	Kohler
Model	Command CV17
Category	Engine
Language	English