Repair
Exhaust gas aftertreatment system (depending on configuration)
Fig. 282: Connector locking device - handling forbidden
u Connect 10-pin connector 6 to pump 1.
Information
It is forbidden to handle the connector locking device on the pump side.
Only use the lock on the harness side to connect 10-pin connector 6.
u Run the system for 30 minutes to confirm successful priming and leak-free operation.
Specific values
Not applicable.
Tightening specifications
Refer to standard tightening torques. (For more information see: 5.3 Standard tightening
torques, page 268.)
KD62V12 33525088601_8_1 EN_US
2022-09
© 2022 by Kohler Co. All rights reserved.
257
To Next Page
Loading...
